China Hardened reducer manufacturer
Hardened reducer is one of the most commonly used types of reducers in the industry, which is divided into many specifications and models. As is well known, only when the oil level is sufficient, the hardened reducer can operate normally and effectively reduce the wear of internal components. However, there is a problem that troubles everyone, which is oil return. Once oil return occurs, it not only fails to provide the original lubrication function, but may also cause damage to the equipment.
China Hardened reducer manufacturer:How to avoid oil return phenomenon, the operation is as follows:
1. The motor port of the hard tooth reducer is equipped with an inflation valve.
2. Add a pipe to the oil hole.
3. The fuel tank and exhaust valve are moved to the side.
4. Separate the oil on the left side of the exhaust valve of the hard tooth reducer from other oils, with the oil level slightly higher than the partition wall.
5. The sealing part of the shaft seal should be reliable and replaced in a timely manner.
6. In order to cut off the oil circuit during shutdown, an oil motor and auxiliary mechanism are installed.
7. Set the check valve mechanism of the hardened reducer to automatically close the oil inlet when the machine is stopped.
8. Keep the base flat and add elasticity to the valve plate.
Therefore, it is necessary to pay attention to the problem of oil return in hardened reducers, and once oil returns, measures should be taken immediately to solve it.
Address：Zibo, Shandong
WhatsApp：+8615805335335
Wechat： +8615805335335 
E-mail：zs@sdsmachinery.com
