Soft tooth surface reducer manufacturer

When using the soft tooth surface reducer,there may be a temperature rise.We know that if its temperature is too high,it can easily cause damage to the machine.This requires us to control the temperature,and to control it,we need to test the temperature rise.Let's follow the soft tooth surface reducer manufacturer testing method to take a look:

1.Determination of working temperature

The measurement of temperature rise of the tested soft tooth surface reducer is usually carried out simultaneously with the measurement of the bearing capacity and transmission efficiency of the reducer,or separately.When the tested reducer meets the requirements,its working temperature at rated speed and rated input power is read.

2.Measurement of Environmental Temperature

Place a thermometer 1.5m away from the surface of the ZQ gearbox being tested.The height of the thermometer measuring point from the ground should be equal to the axis of the gearbox.The placement of the thermometer should not be affected by external radiation heat and airflow.The reading of the ambient temperature value and the reading of the working temperature value should be carried out simultaneously.

3.Temperature rise calculation

The temperature rise is calculated according to the following formula:

In the formula:Δt-temperature rise of soft tooth surface reducer,℃.

Operating temperature at rated speed and rated input power,℃;Environmental temperature,℃.t2——t1——Δt=t1–t2。

Through the above introduction,we have learned that the application of soft tooth surface reducer is quite common,and the equipment is easy to operate.In order to better use and maintain it,its temperature should be well controlled.