QJR-D medium hard tooth surface reducer

Some equipment that runs too fast may use QJR-D medium hard tooth surface reducers to control its speed and prevent wear and tear caused by rapid rotation. To ensure the normal use of the equipment, certain steps need to be followed during installation. Below is an introduction to the assembly of QJR-D medium hard tooth surface reducer:

1. Assemble the shaft, gears, and rolling bearings in a reasonable order, paying attention to the direction; The reasonable assembly and disassembly method of rolling bearings should be followed, including the oil blocking ring and sealing ring, and the axial clearance should be adjusted.

2. Close the cover of the QJR-D medium hard tooth surface reducer.
3. Install the positioning pin properly.
4. Assemble the connecting bolts between the upper and lower boxes of the QJR-D medium hard tooth surface reducer.
5. Assemble the bearing cover and observe the hole cover plate.
When assembling the QJR-D medium hard tooth surface reducer, attention should be paid to the installation sequence. After the equipment is assembled and tested without any abnormalities, it can be officially put into industrial production use. Everyone must strictly follow the installation procedures and be careful.